Installing 3dm2 and cli is working out of the box in ubuntu (tested: 14.04LTS, 16.04LTS), just run the shell script from the install. When building raids use the lower ports first, because you can also switch to a 9650 card with fewer ports easily as long as the higher ports are not used on the original card.Īvoid the first x16 pci express port on the motherboard, some motherboards are expecting video cards there, causing strange behavior. You can switch cards, but use the same firmware (or newer if same version is not available). They are still working (most of them made around 2007 perhaps?)ĭid not see a failing battery yet, after 8-9 years (using them in ideal conditions, batteries always checked, charged). The low profile 9650SE cards are later made and they work fine in modern uefi, etc. In older motherboards they work fine (tested in core2 motherboards). Some info on using 3ware 9650 raid cards in modern, common motherboards:Īvoid full size 9650 cards as they don't work with newer motherboards, bios fails to kick in after soft reset. Has anybody performed a card swap before?Įdit: These are the kernel errors we see: 3ware 9000 Storage Controller device driver for Linux v2.26.02.012.ģw-9xxx 0000:09:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18ģw-9xxx 0000:09:00.0: setting latency timer to 64ģw-9xxx: scsi0: ERROR: (0x06:0x000D): PCI Abort: clearing.ģw-9xxx: scsi0: ERROR: (0x06:0x001F): Microcontroller not ready during reset sequence.ģw-9xxx: scsi0: ERROR: (0x06:0x0036): Response queue (large) empty failed during reset sequence. We've ordered a new one, but I'm worried that if we replace the card it won't recognize the existing array. The OS eventually boots, but alas, without the card. We're using it in a Silicon Mechanics R272 machine with gentoo for the OS. The firmware on it has been upgraded in the past, so it's possible we've hit some sort of firmware bug. Now, when we turn the machine on, the bios option rom that normally kicks in before the bootloader doesn't show up, none of the drives start, and when the OS tries to access the device, it just times out. This card has been in service for a couple years without problems, and was working up until the shutdown. We had to bring the server down for a pending power outage, and when we turned the machine back on, the raid card never started. We have a 8-port 3ware 9650se raid card for our main disk array.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |